Girijya Waldode

Objective: Take samples from the south side and north side of dome dryer to get more accurate data. Procedure: Learning from the previous experiment we have decided to follow the procedure given below, Take 3.5 kg sawdust.Mix 11 liter water in sawdust.Leave the mixture for half an hour.After that do the weight of it.Take 10 … Continue reading Assignment NO 11(DD Data Collection) →

Objective: Try to reduce hurdles in drying saw dust. Procedure: By referring 27th DEC'18 experiment I followed that procedure. I have loaded new batch on 28th DEC'18 having a mixture of 3 kg sawdust and 9 kg water. Batch started at 1 pm. I took 5 samples from this batch, the result is as follows; … Continue reading Assignment No 10(DD Data Collection) →

Objective: The batch loaded on 20th DEC'18 was failed because of the electricity problem. We didn't get any proper data. To see all possible replacement to electricity. Procedure: To see proper content of water hold by saw dust I did experiment on 27th DEC'18. I did the following procedure, First, take 3.164 kg sawdust and … Continue reading Assignment No 9(DD Data Collection) →

Objective: Do an experiment on sawdust. Because it haw low cost and it can be reused again. For that, I have taken LOD of black sawdust and black saw dust and LOD of black saw dust was 80.9210% and white saw dust was 89.679%. Procedure: The procedure followed was as per the previous experiment, I … Continue reading Assignment NO 8(DD Data Collection) →

Objective:  List out all problems related to drying apparatus. Learning from the previous experiment on drying apparatus In the previous experiment, I have collected data about the drying apparatus but there some problems were found because of that it was not working well. On 16th DEC'18 Ameya and I did one experiment on water using … Continue reading Assignment NO 7(DA Data Collection) →

Objective: Do an experiment on green gram whole. Procedure: On 11th DEC'18 I did experiment on Moth Beans as we have decided. The LOD of wet Moth Beans in laboratory oven was 62.32 % and dry Moth Beans was 7.2 %. Later we decided to do an experiment on Green Gram Whole because it will … Continue reading Assignment NO 6 (DD Data Collection) →

Objective: Do water trials on drying apparatus. What is the drying apparatus? Drying Apparatus is device used to interpret drying pattern for a substrate. The Drying apparatus interprets following things, Humidity of inlet airTemperature of inlet airAirflowHumidity of outlet airTemperature of outlet airReal time weight loss in substrate Block Diagram of Drying Apparatus Block diagram … Continue reading Assignment No 5(DA Data Collection) →

Objective: This trial is done on an onion. Learning from previous experiments did on an onion. This time we did some changes to make more efficient drying. Procedure: The procedure I followed was as follows, I took 17 Kg onion to cut.It had 5 kg of waste and 12 kg clean onion.I have a spread-ed … Continue reading Assignment No 4 (DD Data Collection) →

Objective: Do an experiment on Moringa Oleifera Leaves. Procedure: This batch was loaded on 23 NOV'18. The procedure followed was as follows, 12 kg of moringa leaves taken and loaded on dome dryer.Started dome dryer.Started Temperature and humidity sensor.Took 10 gm sample for LOD Fig1. Moringa Leaves weighting for LOD The LOD of drumstick leaves(Oven) … Continue reading Assignment No 3(DD Data Collection) →

What I learned from the first experiment? We observed the onion slices are not evenly divided, because of that it took more time to dehydrate.We did the calculation using each plate surface area and we found we have to load only 12 kg onion slices instead of 25 kg for proper drying.This time we decide … Continue reading Assignment No 2 (DD Data Collection) →